The mold is known to all occupation of modern industrial development in the first pillar, along with the rapid development of modern industry, is the development and application of raw materials is the variety of goods. Manufacturers show: this will promote the diversification of the mold profession, including die casting mold, plastic mold, silicone mold, stamping die, pouring mold, sheet metal mold and so on. Today in detail for us to analyze the difference between die-casting mold and plastic mold, as well as common sense.
Die casting and plastic mold structure is the same, it should be said that plastic mold will do, it should be done die casting die. The primary difference between the two is at the gate set feeding on the gate set of plastic mold is feeding elongated taper, the inlet diameter is relatively small; and the feed mold export is relatively large, the center feeding taper inlet diameter than the feeding of plastic mould export more. Another inlet is a straight round sleeve with a diameter of three and forty millimeters. This is the structure that the plastic mold does not have.
In addition, plastic mold and die casting in the use of the manufacture of steel is not the same; plastic mold usually use 45# steel, T8, T10 and other steel, and die-casting mold is the first use of such heat-resistant steel 3Cr2W8V.